Follow these tips to get those crisp, wrinkle-free clothes you’re looking for!
Before You Start
1. Check Over Your Clothing
Check over garments for any dirt or stains. Ironing over these will set the stains and make them more difficult to remove.
Make sure to check the laundry tag on your garment to determine the fabric type and to see if there are any specific recommendations listed. Look for the iron symbol and check the temperature and steam settings:
One dot: < 110 C (230 F)
Two dots: < 150 C (300 F)
Three dots: < 200 C (390 F)
Tip: When ironing a blended fabric, choose the lowest temperature setting of the two.
2. Organize Your Items
If you have a variety of items you will be ironing, start with those items requiring lower heat and work your way up to the higher temperature garments. Wool and blend fabrics will require lower temperature settings while 100 percept cotton items can typically be ironed at the hotter settings.
3. Prepare Your Iron
If your iron has a water reservoir, fill this up using distilled or bottled water to help minimize mineral build up.
Basic Ironing Tips
- Always iron using an ironing board.
- If you would like your clothing to be more crisp, spray your clothing with a spray starch just prior to ironing. This will also make it easier to iron and will make clothes more resistant to wrinkles throughout the day.
- Always keep the iron moving to avoid any fabric burns. For difficult wrinkles, spray lightly with water and iron over it with steam.
- As you complete each section, move the item away from you to avoid further wrinkling.
- Pull out the pockets (both front and back) and iron them first. If the pockets are wrinkled and you iron over top, you will make the wrinkles worse.
- Iron around the waistband by pressing down and lifting the iron up rather than just pushing it along the fabric. If there are any pleats, fold them in place and iron them down (again, by pressing down and then lifting up).
- Starting at the bottom of your pants, iron up the length of each of the leg. Remember to iron on both sides of each pant leg.
- To create a crease for dress pants, place a single pant leg on the ironing board ensuring the inseams are directly over each other. Press the iron down at the top and bottom of the leg (at the top of the leg, the crease should end at the bottom of the pockets) and then press in the rest of the crease between these two points.
- It is easiest to iron sheets when they are slightly damp.
- Fold the sheet in half or into quarters depending on the size of the sheet.
- Place your sheet over the ironing board and iron in a back and forth motion until dry.
- Shirts are easiest to iron if they are slightly damp. If your shirt is not coming directly from the dryer, mist it with a few sprays from a water bottle.
- Iron the collar first. Turn the collar up and start pressing the underside of the collar from one point to the other. Flip over and repeat on the other side of the collar.
- Unbutton the shirt cuffs and lay flat on the ironing board to iron. Do notiron over the buttons.
- To iron the shirt fronts, start on the side that has the buttons and carefully work your iron around the buttons without ironing over them.
- Sleeves are best ironed using a sleeve board. If you do not have one of these, ensure that both layers of the sleeve are lined up along the seam with no wrinkles before pressing.
Do you have any ironing tips that save time? Share them in the comments section below!